Pitney-bowes DI600 Inserting System Instrukcja Użytkownika Pobierz pdf (Strona 38)

3 • Operator Functions

3-8 SV40221 Rev. C

SwiftStart™

SwiftStart™ allows you to load material into the feeders and run a

simple job with minimal setup information.

The job can then either be run without saving it to the machine’s

memory, or a Supervisor can name and save the Job Definition for

future recall as and when required.

TIP:

SwiftStart™ can be used as a way to quickly

programme a new Job Definition. Load material and run

SwiftStart™. A Supervisor can save the new job and

then use the Edit Job function (see page 4-4) to make

minor changes, if necessary.

Constraints and Requirements

• Only use closed flap envelopes.

• Feeds only single sheets from each Sheet Feeder.

• This mode cannot be used to run fold only or inserts only.

• You cannot link Sheet Feeders in this mode.

• The Envelope Sealer is always on (except for the Trial

Piece).

• The Batch Count is always off.

• The Sheet Length must be 11-1/2” (292mm).

• This mode will not work with OMR.

Loading Material for SwiftStart™

Loading Sheet Feeders

Depending on your envelope depth, the machine will automatically

select the fold type – Single or C (standard) fold.

For example, a standard sheet (8-1/2” x11”) inserted into a #10

envelope will receive a C fold, whereas a standard sheet inserted

into a 6” x 9” envelope will only receive a Single fold.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 127 128

Brak uwag

Pitney-bowes DI600 Inserting System Instrukcja Użytkownika Strona 38