Pitney-bowes DI425 FastPac Inserting Systems Instrukcja Użytkownika Pobierz pdf (Strona 37)

Operation • 2

2-21SV61656 Rev. A

Testing the Job

Load material and press Trial Piece so that you can check if the

setup is correct.

You can make minor changes to the job settings at this stage if the

trial piece needs fine tuning. Press Setup, then use the Prev (◄),

Next (►) and Change (+/-) buttons as required to modify job set-

tings. The chart below will help you fine tune your fold settings.

FOLD TYPE ADDRESS TOO LOW ADDRESS TOO HIGH

C - Letter Fold Decrease Fold A Increase Fold A and

increase Fold B by

the same amount

Z - Accordion Increase Fold A Decrease Fold A a

Fold increase Fold B by

the same amount

Single Fold Increase Fold A Decrease Fold A

Double Fold Decrease Fold A Increase Fold A

We suggest that you change folds by 0.20 inches (5mm) each time

and run a new trial piece run to test the settings.

When you’ve made the necessary changes, press Setup again to

return to run mode. The machine will save the job with the new set-

tings.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 99 100

Brak uwag

Pitney-bowes DI425 FastPac Inserting Systems Instrukcja Użytkownika Strona 37